ThinkPad T43 集成网卡的 Boot Agent 设置
程序员文章站
2022-07-11 22:33:03
ThinkPad T43 集成网卡的 Boot Agent 设置ThinkPad T43 系列机型集成了 Broadcom网卡 ,在开机的时候可以按 Ctrl S 进入网卡的 Boot Agent 设置 开机后用户会看到屏幕上的提示信息Broadcom NetXtreem Ethernet Boot Ag... 08-11-28...
thinkpad t43 系列机型集成了 broadcom网卡 ,在开机的时候可以按 ctrl s 进入网卡的 boot agent 设置
开机后用户会看到屏幕上的提示信息
broadcom netxtreem ethernet boot agent v7.7.5
copyright (c) 2000-2004 broadcom corporation
all right reserved
press ctrl-s to enter configuration menu ...
按ctrl s进入后,看到如下的界面,[]里的是其他的选项
broadcom netxtreem ethernet boot agent v7.7.5
copyright (c) 2000-2004 broadcom corporation
all right reserved
======================================================================================
mba configuration menu
boot protocol preboot execution environment(pxe)
boot strap type auto detect
hide setup prompt disable[enable]
setup key stroke ctrl-s[ctrl-b]
banner message timeout none[1 second, 2 second]
link speed autoneg[10mbps half,10mbps full,100mbps half,100mbps full]
pre-boot wake on lan enable
bus = 02 device = 00 func = 0
======================================================================================
<esc> <ctrl-f6> <left/right> <up/down> <f4>
quit blink leds change value change field save
修改好之后按f4保存退出就可以了
开机后用户会看到屏幕上的提示信息
broadcom netxtreem ethernet boot agent v7.7.5
copyright (c) 2000-2004 broadcom corporation
all right reserved
press ctrl-s to enter configuration menu ...
按ctrl s进入后,看到如下的界面,[]里的是其他的选项
broadcom netxtreem ethernet boot agent v7.7.5
copyright (c) 2000-2004 broadcom corporation
all right reserved
======================================================================================
mba configuration menu
boot protocol preboot execution environment(pxe)
boot strap type auto detect
hide setup prompt disable[enable]
setup key stroke ctrl-s[ctrl-b]
banner message timeout none[1 second, 2 second]
link speed autoneg[10mbps half,10mbps full,100mbps half,100mbps full]
pre-boot wake on lan enable
bus = 02 device = 00 func = 0
======================================================================================
<esc> <ctrl-f6> <left/right> <up/down> <f4>
quit blink leds change value change field save
修改好之后按f4保存退出就可以了
上一篇: 英特尔迅驰4无线技术解析
下一篇: logback