组播排错的命令
组播排错的命令
r1#sh ip pim ap
r1#sh ip pim rp
r1#sh ip pim rp
看不到RP
r1#sh ip mroute
IP Multicast Routing Table
Flags: D – Dense, S – Sparse, B – Bidir Group, s – SSM Group, C – Connected,
L – Local, P – Pruned, R – RP-bit set, F – Register flag,
T – SPT-bit set, J – Join SPT, M – MSDP created entry,
X – Proxy Join Timer Running, A – Candidate for MSDP Advertisement,
U – URD, I – Received Source Specific Host Report,
Z – Multicast Tunnel, z – MDT-data group sender,
Y – Joined MDT-data group, y – Sending to MDT-data group
Outgoing interface flags: H – Hardware switched, A – Assert winner
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode
(*, 224.0.1.39), 00:28:29/stopped, RP 0.0.0.0, flags: DC
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
Ethernet0/1, Forward/Sparse-Dense, 00:28:29/00:00:00
Serial0/0, Forward/Sparse-Dense, 00:28:29/00:00:00
(10.10.4.4, 224.0.1.39), 00:18:58/00:02:51, flags: T
Incoming interface: Serial0/0, RPF nbr 10.10.11.4
Outgoing interface list:
Ethernet0/1, Forward/Sparse-Dense, 00:18:59/00:00:00
(*, 224.0.1.40), 00:28:43/stopped, RP 0.0.0.0, flags: DCL
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
Ethernet0/1, Forward/Sparse-Dense, 00:28:43/00:00:00
Serial0/0, Forward/Sparse-Dense, 00:28:43/00:00:00
(10.10.4.4, 224.0.1.40), 00:10:16/00:02:39, flags: LT
Incoming interface: Serial0/0, RPF nbr 10.10.11.4
Outgoing interface list:
Ethernet0/1, Forward/Sparse-Dense, 00:10:17/00:00:00
看不到正确的组
r1#ping 224.30.30.30
Translating "224.30.30.30"
Type escape sequence to abort.
Sending 1, 100-byte ICMP Echos to 224.30.30.30, timeout is 2 seconds:
Reply to request 0 from 10.10.11.4, 104 ms
组可以PING通
再SHOW RP, 已经显示加入组?原因,不知,可能PIM进程要激活,
r1#sh ip pim rp
r1#sh ip pim rp
Group: 224.30.30.30, RP: 10.10.4.4, v2, v1, uptime 00:10:48, expires 00:02:04
Group: 224.50.50.50, RP: 10.10.4.4, v2, v1, uptime 00:10:48, expires 00:02:02
下一篇: 曹操帐下猛将如云,最勇猛的将领是谁呢?