STM32--串口

void USART1_Configuration(void)
{

GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
NVIC_InitTypeDef NVIC_InitStructure;

RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOB,ENABLE); //使能GPIOA时钟
RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1,ENABLE);//使能USART1时钟

//串口1对应引脚复用映射
GPIO_PinAFConfig(GPIOB,GPIO_PinSource6,GPIO_AF_USART1); //GPIOA9复用为USART1
GPIO_PinAFConfig(GPIOB,GPIO_PinSource7,GPIO_AF_USART1); //GPIOA10复用为USART1

//USART1端口配置

GPIO_InitStructure.GPIO_Pin = GPIO_Pin_6 | GPIO_Pin_7; //GPIOA9与GPIOA10
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF;//复用功能
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz; //速度50MHz
GPIO_InitStructure.GPIO_OType = GPIO_OType_PP; //推挽复用输出
GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_UP; //上拉
GPIO_Init(GPIOB,&GPIO_InitStructure); //初始化PA9，PA10 //初始化GPIOA的PIN10

//USART1 初始化设置
USART_InitStructure.USART_BaudRate = 9600;//波特率设置
USART_InitStructure.USART_WordLength = USART_WordLength_8b;//字长为8位数据格式
USART_InitStructure.USART_StopBits = USART_StopBits_1;//一个停止位
USART_InitStructure.USART_Parity = USART_Parity_No;//无奇偶校验位
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;//无硬件数据流控制
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx; //收发模式
USART_Init(USART1, &USART_InitStructure); //初始化串口1

USART_Cmd(USART1, ENABLE); //使能串口1

USART_ClearFlag(USART1, USART_FLAG_TC);
USART_ITConfig(USART1, USART_IT_RXNE, ENABLE);//开启相关中断

//Usart1 NVIC 配置
NVIC_InitStructure.NVIC_IRQChannel = USART1_IRQn;//串口1中断通道
NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority=3;//抢占优先级3
NVIC_InitStructure.NVIC_IRQChannelSubPriority =3;		//子优先级3
NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE;			//IRQ通道使能
NVIC_Init(&NVIC_InitStructure);	//根据指定的参数初始化VIC寄存器、

}

本文地址：https://blog.csdn.net/weixin_42215853/article/details/109643903