stm32 下载程序出现以下问题:JLink Info: Found SWD-DP with ID 0x1BA01477
stm32 下载程序出现以下问题:
-
JLink Info: Found SWD-DP with ID 0x1BA01477
-
JLink Info: Found SWD-DP with ID 0x1BA01477
-
JLink Info: TPIU fitted.* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
-
JLink Info: Found Cortex-M3 r1p1, Little endian.ROMTableAddr = 0xE00FF003 **JLink Warning: S_RESET_ST not cleared
**JLink Warning: CPU did not halt after reset.
**JLink Warning: CPU could not be halted
- JLink Info: Core did not halt after reset, trying to disable WDT.
**JLink Warning: CPU did not halt after reset.
**JLink Warning: CPU could not be halted
**JLink Warning: S_RESET_ST not cleared
-
JLink Info: Found SWD-DP with ID 0x1BA01477
-
JLink Info: TPIU fitted.* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
-
JLink Info: Found Cortex-M3 r1p1, Little endian.
**JLink Warning: S_RESET_ST not cleared
**JLink Warning: CPU did not halt after reset.
**JLink Warning: CPU could not be halted
- JLink Info: Core did not halt after reset, trying to disable WDT.
**JLink Warning: CPU did not halt after reset.
**JLink Warning: CPU could not be halted
**JLink Warning: S_RESET_ST not cleared
**JLink Warning: CPU could not be halted
单片机的reset管脚用了一个电阻接到3.3V，一个电容接地。测了一下reset脚的电压0.6V。
解决成功一:打了一下reset到地电阻100欧左右，去掉电容，就能下程序了，电容损坏。
本文地址：https://blog.csdn.net/ad33332222/article/details/107942731